Working With The Equipment; Fitting - Parkside PFR 28 A1 Originalbetriebsanleitung

GB CY

Working with the equipment

Caution: to avoid accidents and
injuries:
Never reach under the patio clean-
er when it is on.
CAUTION. pressure wash-
ers can be dangerous if they
are not operated correctly!
The jet must never be direct-
ed at people, animals, elec-
tric equipment con-nected to
the power supply or against
the actual pressure washer.
• Do not direct the jet at yourself or others
in order to clean clothes and shoes.
• Do not operate the pressure washer
when other people are in the immedi-
ate vicinity, other than they are also
wearing protective clothes.
• Do not start the high-pressure wash un-
til the patio cleaner rests on the surface
you are cleaning.
• Take appropriate measures to keep chil-
dren away from the equipment whilst it
is running.
• Dispose of the packaging material cor-
rectly.
• Do not use the equipment in the vicinity
of flammable liquids or gases. Non-
observance will result in a risk of fire or
explosion.
• Store the equipment in a dry place and
out of reach of children.
• Children should be supervised to en-
sure that they do not play with the ap-
pliance.
Caution! To avoid damage to the
equipment and any possible person
injury resulting from this:
6
• Do not work with damaged or incom-
plete equipment, or with equipment
that has been converted without the ap-
proval of the manufacturer.
• Protect the patio cleaner from frost
• Use only original accessories and do
not carry out conversion work on the
equipment.

Fitting

• Screw the connection pipe (5)
into the pivoting connector (6).
• To extend your reach, snap on
and turn the bayonet mount of
the pipe extension (4) to the con-
nection pipe (5).
• To connect to the pressure wash-
er, snap the bayonet mount into
the pressure washer's jet gun.
• When you use the extension ele-
ment (4) screw the retainer nut (3)
against the spray gun.
Alternative connection with
adapter
To connect
- Fit the adapter (1) onto the
extension element (4) or the con-
nection pipe (5) of the PARKSIDE
accessory and turn through 90°
until it clicks into place (Bayonet
catch). Screw the nut (3) to the
adapter (1).
.
- Connect the pressure washer
jet gun (8) (Bayonet catch) and
tighten the retainer nut (2) on the
adapter (1).