Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

It is the responsibility of the user to analyse the
surface to be treated. The user should make a risk
assessment on the basis of the information obtained
about the surface to be treated and take proper
precautions for the work to be performed.
Do not use the product in fog, rain, strong winds,
cold weather, risk of lightning or other bad weather
conditions.
Look out for persons, objects and situations that can
prevent safe operation of the product.
Do not use the product in areas where fire or
explosions can occur. The product creates sparks
and flammable material can create ignition with the
dust or fumes.
Keep children, bystanders and animals away from
the work area and at a safe distance from the
product. Safe distance is 15 m.
Make sure that bystanders and animals are not
in the work area and at a safe distance from the
product.
Make sure that only approved persons are in the
work area.
Keep the work area clean and fully illuminated.
Cluttered or dark areas invite accidents.
Remove objects such as screws, bolts, wires and
stones from the work area before you use the
product.
Make sure that there are no cables or hoses in the
operation direction of the product.
Make sure that uneven surfaces, such as welded
seams or floor joints, do not stop the product.
Make sure that there is sufficient airflow in the work
area.
8

Electrical safety

WARNING:
shocks from electrical products. Do not use
the product in bad weather conditions. Do
not touch lightning conductors and metal
objects. Always use the product as given in
this operator's manual to prevent injury.
WARNING:
with RCD (residual-current device). An RCD
decreases the risk of electrical shock.
WARNING:
unprotected parts in the power unit. Always
disconnect the power plug before you open
the door to the electrical box.
CAUTION:
product or generator must be sufficient and
constant to make sure that the motors
operate without problems. Incorrect voltage
causes the power consumption and the
temperature of the motors to increase until
the safety circuit releases. The dimension
of the power cord must agree with national
and local regulations. The dimension of the
mains socket must agree with the amperage
for the electrical socket and extension cable
of the product.
If the power mains has higher system
resistance, short voltage drop can occur
when the product is started. This can
influence the operation of other products, for
example flicker on the lights.
The power plug must match the outlet. Never modify
the plug in any way. Do not use any adapter plugs
with earthed (grounded) power tools. Unmodified
plugs and matching outlets will reduce risk of electric
shock.
Avoid body contact with earthed or grounded
surfaces, such as pipes, radiators, ranges and
refrigerators. There is an increased risk of electric
shock if your body is earthed or grounded.
Make sure that the power, fuse and mains voltage
are the same as the voltage shown on the rating
plate of the product.
Always stop the product before you disconnect the
power plug.
Make sure that the ON/OFF switch is in OFF position
before the product is connected to the power supply.
Always disconnect the power plug during a long
product stop.
Do not use the product if the power cord or power
plug is damaged. Let an approved service center
There is always a risk of
Always use a power supply
High voltage. There are
The power supply from the
2037 - 002 - 06.04.2023

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Inhaltsverzeichnis