Husqvarna 2-20DT Bedienungsanweisung Seite 19

4. Examine the position of the control cage window.
5. Turn the left control cage (B) clockwise, if the
hotspot is too much in the middle.Turn the right
control cage (B) counterclockwise, if the hotspot is
too much in the middle
2037 - 002 - 06.04.2023
6. Turn the left control cage (B) counterclockwise, if the
hotspot is too much on the left side. Turn the right
control cage (B) clockwise, if the hotspot is too much
on the right side.
7. Make sure that the hotspots are equaly applied on
the surface for correct adjustment.
8. Tighten the cage clamps when the control cage is in
correct position.
9. Attach the feedspout.
19