Husqvarna 1-10DS Bedienungsanweisung Seite 19

3. Attach the dust extractor hose safely to the
connection for dust extractor (A). Connect the
attached parts with the supplied tool and industrial
tape.
4. Install the dust extraction hose in the dust hose
holder (B).
To connect the product to a power
source
1. Connect the power plug of the product to a grounded
mains outlet or other power source.
2. Make sure that the mains voltage agrees with the
type plate on the product.
Warning lamp of the blastmotor
protection and fault power supply
The warning lamp of the blastmotor protection comes
on when there is a fault in the power supply. The
blastmotor can not start when the lamp is on. Disengage
the blastmotor protection to start the blastmotor. Refer to
To disengage the blastmotors protection on page 19 .
To disengage the blastmotors
protection
1. Change the phases position.
2. Do a check of the warning lamp of the blastmotor
protection. If the ligth is still on, the power supply is
not correct.
3. Do a check of motor protection switch in the
electrical enclosure.
4. Do a check of the warning lamp of the blastmotor
protection. If the ligth is still on, the power supply is
not correct.
5. Do a check of all phases with a multimeter. Connect
the missing phases.
2070 - 004 - 06.04.2023
6. Start the blastmotor. Refer to
7. Do a check of the warning lamp of the blastmotor
A
To select the correct speed
It is important to do the operation with correct drive
speed for best result. If the surface has different quality,
adjust the drive speed for an equal result. Examine the
result and adjust the speed if it is necessary.
B
•
•
To start the product
1. Connect the product to a power supply. Refer to
2. Start the dust extractor. Refer to the operator's
3. Attach the dust extractor hose to the product. Refer
4. Make sure that the emergency stop button is
5. Turn the ON/OFF switch to the ON postion.
page 19 .
protection. If the ligth is still on, speak to your
HUSQVARNA service agent.
Turn the speed control dial clockwise to increase the
speed.
Turn the speed control dial counterclockwise to
decrease the speed.
a) Use drive speed 6–10 on concrete surfaces for
light treatment.
b) Use drive speed 0–5 on concrete surfaces for
heavy treatment.
c) Use drive speed 0–2 on steel surfaces.
connect the product to a power source on page 19 .
manual of the dust extractor.
To connect a dust extractor on page 18 .
to
disengaged.
To start the product on
To
19