Husqvarna 1-10DS Bedienungsanweisung Seite 15

3. Open the drive chain cover.
4. Pull out the quick-release pin.
5. Put the quick-release pin in the storage position.
6. Close the drive chain cover.
Abrasive valve
The abrasive valve controls the flow of the abrasive
shots to the blastwheel. The adjustment of the abrasive
valve is shown on the ammeter. Refer to
page 12 .
The abrasive valve is adjusted with the abrasive control
To operate the abrasive valve on page
lever. Refer to
15 .
To operate the abrasive valve
CAUTION:
valve when the blast motor is in operation.
2070 - 004 - 06.04.2023
Ammeter on
Only open the abrasive
1. Pull the abrasive control lever to open the abrasive
valve and adjust the flow of abrasive shots.
2. Push the abrasive control lever to close the abrasive
valve and adjust the flow of the abrasive shots.
Abrasive seal
The abrasive seal makes sure that the abrasive stays
in the product during operation. The abrasive seal has
magnetic seals (A) on the sides and in front of the
blast housing. Brush lists (B) are attached around the
magnetic seals.
The skid seal (C) moves on the surface.
A
B
C
15