Husqvarna 1-10DS Bedienungsanweisung Seite 14

3. Set the movement speed to the lowest possible,
approximately 0.5.
4. Open the drive chain cover.
5. Install the quick-release pin. Push and hold the
quick-release pin with a finger.
14
6. Use your other hand to operate the drive system
lever.
The quick-release pin locks into position when the
drive system is engaged.
7. Close the drive chain cover.
8. To disengage the drivesystem, refer to
the drive system on page 14 .
To disengage the drive system
CAUTION:
system when the product is parked on level
surface.
If it is necessary to move the product manually with
the motor off, the drive system must be disengaged.
Remove the quick-release pin to disengage the drive
system.
1. Park the product on level surface and stop the
product.
2. Disconnect the power supply.
To disengage
Only disengage the drive
2070 - 004 - 06.04.2023