Front Wheel - Kayoba 009925 Bedienungsanleitung

EN
ASSEMBLY
Suitable tools for assembly and adjustment.
• Combination spanners, sized 14 (2) and
15 mm
• Hex keys, size 4 and 5 mm
• Phillips screwdriver PH2
• Grease
HANDLEBARS
1. Unscrew the bracket on the stem with a 5
mm hex key.
FIG. 2
2. Put the handlebars on the stem. Make sure
that it is centred and has a suitable angle
for the handbrake and gear levers, and
that the brake and gear wires are on the
right sides of the frame and front fork. If
the wires are not properly positioned the
handlebars or fork has turned, and must be
turned back before fitting the handlebars.
FIG. 3
3. Screw together the bracket and tighten
the two hex screws alternately.
FIG. 4

FRONT WHEEL

1. Remove transport protection on the brake
calliper, in the form of a small piece of
plastic that separates the brake pads.
2. Put the wheel axle in the slots on the fork
legs and align the brake disc to the brake
calliper. Check that the wheel is straight,
in the middle of the fork legs.
3. Close the quick-release lock and firmly tighten
the adjusting nut on the opposite side.
4. Open the quick-release lock, tighten the
adjusting nut another 3/4 turn, and then
close it again. Closing the quick-release
takes a little effort, so that it does not
open unintentionally and loosen the
wheel.
FIG. 5
28
NOTE:
It is very important that the springs are
positioned on each side of the quick-release
axle, otherwise the bearings in the wheel
axle can gradually become damaged.
SADDLE AND SADDLE POST
Grease the saddle post and insert it into the
saddle tube, and then lock to the required
height with the quick-release.
IMPORTANT:
The marking for the top position on the
saddle post should not be seen over the
saddle tube.
PEDALS
The pedals are different and are therefore
marked with "L" (Left) and "R" (Right). If they
are fitted on the wrong side or screwed in skew
in the crank arms this can damage the threads.
Grease the threads on the pedals before fitting.
FIG. 6
Fitting the right-hand pedal (R)
Screw in the pedal clockwise on the chain side
of the crank arm and tighten with a 15 mm
combination spanner.
FIG. 7
Fitting the left-hand pedal (L)
Screw in the pedal anticlockwise, on the
opposite side of the chain, and tighten with a
15 mm combination spanner.
FIG. 8