13. Troubleshooting
Fault
Hedge trimmer does not
work.
Hedge trimmer cuts with
interruptions
Engine is running, cutting
device does not move
Cutting device gets hot
Possible cause
• No fuel supply
• Fault in the fuel line
• Fuel filter clogged
• Spark plug defective
• Carburettor defective
• Internal fault.
• Internal fault.
• ON / OFF switch defective.
• Cutting device blocked
• Internal fault.
• Clutch defective
• Missing lubrication => friction
• Not enough play
• Cutting blades are blunt
www.scheppach.com
Remedy
• Check the fuel quantity
• Check the fuel line for kinks or damages
• Clean/replace the fuel filter
• Replace the spark plug
• Manufacturer or responsible customer service
must be called
• Manufacturer or responsible customer service
must be called
• Manufacturer or responsible customer service
must be called
• Manufacturer or responsible customer service
must be called
• Remove object
• Manufacturer or responsible customer service
must be called
• Manufacturer or responsible customer service
must be called
• Oil the cutting device
• Adjust the sliding play
• Have the cutting device sharpened
GB | 31