Accessories; Technical Data; Dimensions - Truma Trumatic E 2400 E Gebrauchsanweisung

Accessories

1. Series unit VG 2
for vehicle cab heaters in dangerous goods vehicles in ac-
cordance with ADR (not to be used in conjunction with a
time switch).
2. Exterior switch AS
used to turn the heater on or off outside the vehicle, e.g.
for load compartment heaters (available with 4 m or 10 m
connector cable).
3. Acoustic ASM warner
emits an acoustic signal in the event of malfunctions.
4. Time switch ZUE / ZUE 2
used to pre-programme 3 switch-on times within 7 days,
complete with 4 m connector cable (for 12 V and 24 V on-
board power supply).
ZUE, part no. 39890-00, for installation in existing cut-outs,
suitable for control panel with slide switch.
ZUE 2, part no. 39891-00 with cover frame, suitable for
control panel with rotary switch.
5. Remote sensor FF
monitors the room temperature regardless of where the
control panel is positioned (available with 4 m or 10 m con-
nector cable).
6. Multiple box MSD
used to connect several accessories (e.g. time switch and
remote sensor).
Extension cable for accessories
Items 1-6 are available with 4 m or 10 m (not shown).
7. Direct switch DIS 1
used to operate the heater only in high position without a
temperature control device (available with 10 m connector
cable). Replaces the control panel.
Or direct fixed temperature switch DFS
used to operate the heater with a fixed temperature setting
(40 °C – 70 °C depending on version). Replaces the control
panel.
All electronic accessories are equipped with connectors and
can be connected individually.

Technical Data

Determined in accordance with EN 624 or Truma test conditions
Type of gas
Natural gas (from vehicle-internal CNG system)
Operating pressure
50 mbar (see type plate)
Rated thermal output
Full power: 2400 W
Partial load: 1200 W
Gas consumption
Full power: 240 l/hr
Partial load: 130 l/hr
Air delivery capacity
Full power: approx. 78 m ³ /h
Partial load: approx. 49 m ³ /h
Power consumption at 12 V
Full power: 1.1 A
Partial load: 0.6 A
Power consumption at 24 V
Full power: 0.7 A
Partial load: 0.4 A
Quiescent current consumption
0.01 A
Weight
Heater:
Heater with peripheral devices: 5.1 kg
Declaration of conformity
The device complies with the requirements of the following
EC directives:
– Gas Appliances Directive 90/396/EEC
– Heating Appliance Directive 2001/56/EC, 2004/78/EC,
2006/119/EC
Type approval number e1 00 0144
– EMC directive 2004/108/EC.
– Radio interference suppression in vehicles 2004/104/EC,
2005/83/EC, 2006/28/EC
Type approval number e1 03 2605
– End-of-life vehicle directive 2000/53/EC
The CE product identification number for EU countries is:
CE-0085AO0008
Right reserved to make technical changes!

Dimensions

370
All dimensions in mm.
4.8 kg
24 123
17