Spark Arrestor - Inspect/Clean/Replace; Hot Surface; Spark Plug - Inspect/Adjust/Replace - HBM Machines H130529 Bedienungsanleitung

Wipe off the fuel cap (1) and surrounding area before removing the fuel cap. Wiping off the
fuel cap and surrounding area before removing the fuel cap helps to reduce the amount of
contaminants allowed into the fuel system.
If there is a build-up of debris in the fuel strainer(2), remove the strainer and rinse out the
strainer. Allow the strainer to dry before installing the strainer.
Generator - Inspect
Once a month start the engine and run the engine until it reaches normal operating
temperature (about 20 minutes). Plug in a corded device and turn on the device to ensure
that the generator is providing power. Once you have verified that the generator is
providing power, turn off the device and unplug it. Then turn the generator off.

Spark Arrestor - Inspect/Clean/Replace

This unit has a spark arrestor fitted to the exhaust outlet of the muffler. The spark arrestor
should be cleaned with a soft wire brush after every 50 hours or 3 months of use. The
spark arrestor should be replaced after every 100 hours of operation or if it becomes
damaged.

Hot Surface

Hot parts or hot components can cause burns or personal injury. Do not allow hot parts or
components to contact your skin. Use protective clothing or protective equipment to protect
your skin.
DO NOT perform this maintenance procedure until the muffler has cooled.
Spark Plug – Inspect/Adjust/Replace
Refer to the Specifications section of this manual to determine the proper spark plug part
number and spark plug gap for your product.
4
- 14-