Feet Assembly; Wheel Assembly; Battery Connection (If Equipped) - HBM Machines H130529 Bedienungsanleitung

Feet Assembly

1. Set the frame of the unit on blocks to provide sufficient clearance to install the feet
and wheels.
2. Align the mounting holes of the foot bracket (2) with the mounting holes in the
frame.
3. Insert one 8 mm bolt (1) through each set of mounting holes.
4. Install and hand tighten one 8 mm nut (3) on each bolt.
5. Repeat steps 2 – 4 for the other foot.
6. Tighten all four nuts securely.

Wheel Assembly

1. Insert the wheel axle(Figure 5) into the tyre(Figure 7) as showed in the figure;
2. Insert the wheel axle(Figure 5) with the tyre(Figure 7) into the mounting hole of the
frame;
3. Insert a flat washer(Figure 8) with a diameter of 12mm and then a spring washer(Figure
6) with a diameter of 12mm at the end of the wheel axle, then tighten with a nut(Figure 4);
4. Mount another tyre by repeating steps 1 to 3;
5. Move away the blocking.

Battery Connection (If equipped)

H130529 come with the battery mounted in the battery ho lder.
To connect the battery:
1. The unit ships with the positive battery cable (1) already connected.
2. Attach the cable with the black cap (2) to the negative battery terminal.
2
1
- 4 -