Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Oil Viscosities
SAE 0W-40
SAE 5W-40
SAE 10W-30
SAE 15W-40
4. After adding oil, install and tighten the oil filler cap.
Note:
Non-detergent and 2-stroke engine oils will damage the engine and must not be
used.
Engine Oil – Change
1. Operate the engine until it reaches normal operating temperature. Stop the engine
and use a suitable container to collect the used oil.
2. Remove the oil filler cap (1) and drain plug (3) to drain the oil.
3. Reinstall the drain plug and tighten to 18 ± 2 lb ft (24 ± 3Nm).
4. Refill the oil and check the oil level. Refer to Engine Oil Level(2) – Check.
5. Install and tighten the oil filler cap.
6. Dispose of the used oil properly.
Engine Valve Lash – Inspect/Adjust
Only qualified service personnel should perform this maintenance procedure. Contact your
local service center to schedule this maintenance.
Fuel Line – Replace
Only qualified service personnel should perform this maintenance procedure. Contact your
local service center to schedule this maintenance.
Fuel Tank Cap and Strainer – Clean
Recommended Lubricant Viscosities for
Ambient Temperature
。C
-Min
Max
-40
40
-30
50
-18
40
-10
50
1
2
3
-Min
-40
-22
0
14
- 13-
。F
Max
104
122
104
122
Werbung
Inhaltsverzeichnis
Fehlerbehebung
