Parkside PAS 1200 F5 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung Seite 18

Inserting a new pleated filter
Fig . H
Set the on/off switch
Disconnect the power plug
power supply .
Remove the container lid
container (see "Fixing and removing the
5 ] [
container lid") .
Turn over the container lid
one side .
Insert the new pleated filter
mesh .
[ 22 ]
Slide the wire mesh
filter inside over the filter thread
21 ] [
Fixing the pleated filter
mesh : Hold the pleated filter by the
22 ] [
rim . Turn the pleated filter in a clockwise
direction . Once the pleated filter is fixed on
the filter thread
24 ] [
place .
The rim of the wire mesh
down the safety switch
product does not operate .
16 GB
to O .
17 ] [
from the
[ 18 ]
from the metal
[ 14 ]
and put it to
14 ] [
into the wire
21 ] [
with the pleated
22 ] [
.
24 ] [
and the wire
[ 21 ]
, it holds the wire mesh in
has to press
[ 22 ]
. Otherwise, the
[ 23 ]
˜ Storage
Set the on/off switch
the power plug
[ 18 ]
Let the product cool down .
Clean the product (see "Cleaning and
care") .
Wrap the power cord
cord holder .
2 ] [
The nozzles
[ 6 ] 7 ] [
swivel castors during storage (Fig . E) .
Store the product and its accessories in a
dark, dry, frost-free, well-ventilated place .
Always store the product in a place that is
inaccessible to children .
The temperature for long term storage
(longer than 3 months) should be between
+10 and +30 °C with a relative humidity not
above 60 % .
to O . Disconnect
17 ] [
from the power supply .
around the power
18 ] [
can be placed on the