Adjus Ng The Height Of The Clothing Protec On Rims; Adjus Ng The Backrest Incline - Decathlon TW500 Gebrauchsanweisung

NOTE: The wheelchair comes with two sets of backrest extensions. The short set covers a height
adjustment to between 250 and 310 mm. The extended set covers a height adjustment to between 330
and 390 mm. The support straps provided cover the whole adjustment range, just like the padded
canvas cover.
4.6

Adjus ng the height of the clothing protec on rims

It's recommended that you define the posi oning of the protec on height in rela on to the wheels before
con nuing with adjus ng the incline of the backrest, in order to eliminate any clashes and needing to redo any
adjustments.
Removing the drive wheels.
●
Unscrew and remove the "P", "Q", "V" and "Y" screws which a ach the protec on to the frame and
●
which set the adjustment of the backrest incline.
● Determine whether you need to remove the incline adjustment. You need to remove it if the "T"
screw has also been passed through the protec on. In this case, also remove the "T" screw, taking
care to note the sequence of the washers for when you put it back together.
Select the preferred posi on by using the "P" and "Q" slots nearest to the relevant holes.
●
Reinsert all the "P", "Q", "V" and "Y" screws that were previously removed and securely ghten them.
●
If the suppor ng "T" screw has been removed, it must be reinserted first.
4.7

Adjus ng the backrest incline

Before adjus ng the backrest incline, you should make sure that the clothing protec on rim is posi oned at
the desired height. If necessary, first adjust the height of the rim, following the instruc ons provided in
paragraph 4.7 and then con nue as follows with adjus ng the incline of the backrest. Opera ons should
always be carried out symmetrically on the right and le sides, in order to be able to make the required
rota ons. It is recommended that, when the screws are removed, you take note of the sequence of the
washers and thicknesses used, so that you can put them back in the right order.
Unscrew, without removing, the "P" and "Q" screws to release any locked rota ons and movements of
●
12