Adjus Ng The Fore-A Seat Height In Rela On To The Ground; Adjus Ng The Height Of The Backrest - Decathlon TW500 Gebrauchsanweisung

To adjust the fore-a seat posi on of the wheelchair to 420 or 400 mm, use the hardware provided and follow
the instruc ons below:
Remove the front padded frame protectors.
●
Loosen, but do not remove, the "M" screws that secure the frame curve to the seat
●
Unscrew, but don't remove, the "F2" screws to release the rota on between the front mounts of the
●
seat.
Remove the "F1" screws which a ach the "H" interior mounts to the base of the frame.
●
Remove the "H" mounts, the "F1" screws, the "D1" spacers and the "G" screws.
●
Insert the supplied "A1" rods with the inside of the "F" exterior mounts,
●
A ach the "A1" rods to the "F" tube using the "F4" screw, selec ng the hole which corresponds to the
●
height desired.
A ach the exterior mounts to the "M1" bracket using the "F3" screw, "D3" disc washers and "D2"
●
brass sleeves as shown in the illustra on.
If no further modifica on of the seat insert is required, ghten the previously loosened "F2" and "M" screws
properly.
4.4

Adjus ng the fore-a seat height in rela on to the ground

The height of the fore-a seat in rela on to the ground can be adjusted to between 340 and 530 mm by
following the instruc ons below:
Unscrew, without removing, the "F1", "C" and "F2" screws to release any locked rota ons and
●
movement of the seat mount.
● Unscrew and remove the "E" screws which a ach the rear support bars.
Select the desired height of the seat in rela on to the ground, measured from the end of the seat to
●
the ground "RH".
Put back the "E" screws in the new posi on and securely ghten them.
●
If no other changes are required for the seat configura on, securely a ach the "F1" and "F2" screws
●
which were previously unscrewed.
4.5

Adjus ng the height of the backrest

By default, the height of the backrest is set at 290 mm. Nevertheless, it can be adjusted to between 250 and
390 mm by following the indica ons below:
Li and remove the canvas of the backrest, which is a ached by the velcro strips on the support
●
straps.
Unscrew the (F) screws which a ach the adjustment extensions for the backrest height.
●
● Select the new height for the backrest.
Put back the (F) screws into the new posi on and securely ghten them.
●
If you need to add one or more velcro support straps for the external padding.
●
Re-install the backrest canvas, taking care to fold any overhang under the cushion.
●
11