Decathlon TW500 Gebrauchsanweisung Seite 11

4.3 Adjus ng the height of the fore-a
ground
The height of the fore-a seat in rela on to the ground is set at 500mm. The configura on provided can be
adjusted between 440 and 540 mm. The chair also comes with a kit to accommodate front heights of 420 and
400 mm. To adjust the post posi on between 440 and 540 mm, follow the instruc ons below:
Remove the padded protec on from the front of the frame.
●
Unscrew, but don't remove, the "F1" screws which a ach the front mounts to the base of the frame.
●
Unscrew, but don't remove, the "F2" screws to release the rota on of the front mounts in rela on to
●
the seat.
Unscrew and remove the "G" screws which a ach the front telescopic sec ons of the frame.
●
Select the desired seat height in rela on to the ground, measured between the edge of the seat and
●
the ground (FH).
Put back and securely a ach the "G" screws in the new posi on.
●
● If no other changes are required for the seat configura on, properly a ach the "F1" and "F2" screws
which were previously unscrewed.
seat in rela on to the
10