Optional Accessories - Makita UP100D Betriebsanleitung

Upper shear blade
1. Grind the upper shear blade with the grinding
stone as shown in the figure.
► Fig.31: 1. Upper shear blade 2. Grinding stone
2.
Remove the burrs from the back side of the shear
blade by lightly applying the grinding stone to the shear
blade.
► Fig.32: 1. Grinding stone
NOTICE:
When sharpening the back side of
shear blade, lightly apply the grinding stone,
and do not sharpen the shear blade too much.
Otherwise, the clearance may become too much, or
the life of shear blade may be shortened.
• After installing the shear blades, adjust the clear-
ance of shear blades by referring to the section for
adjustment for shear blades clearance.
• After installing the shear blades, apply oil to the
shear blades by referring to the section for shear
blade maintenance.
• After installing the shear blades, adjust the cutting
depth by referring to the section for cutting depth
adjustment.
TROUBLESHOOTING
Before asking for repairs, conduct your own inspection first. If you find a problem that is not explained in the manual,
do not attempt to dismantle the tool. Instead, ask Makita Authorized Service Centers, always using Makita replace-
ment parts for repairs.
State of abnormality
The shear blade does not move even
after pulling the switch trigger.
The shear blades are stuck on the
branch.
The cut is not smooth.

OPTIONAL ACCESSORIES

CAUTION:
These accessories or attachments
are recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or attachment
for its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
• Upper shear blade
• Lower shear blade
• Grinding stone
Probable cause (malfunction)
The battery is low.
The tool is turned off.
Switch trigger defect.
The branch is too thick or too hard.
The shear blades are dull.
The shear blades are worn out.
14 ENGLISH
Lower shear blade
1. Grind the lower shear blade with the grinding
stone in the direction of the arrow as shown in the
figure.
► Fig.33: 1. Grinding stone 2. Lower shear blade
2.
Remove the burrs from the back side of the shear
blade by lightly applying the grinding stone to the shear
blade.
► Fig.34: 1. Grinding stone
NOTICE:
When sharpening the back side of
shear blade, lightly apply the grinding stone,
and do not sharpen the shear blade too much.
Otherwise, the clearance may become too much, or
the life of shear blade may be shortened.
• After installing the shear blades, adjust the clear-
ance of shear blades by referring to the section for
adjustment for shear blades clearance.
• After installing the shear blades, apply oil to the
shear blades by referring to the section for shear
blade maintenance.
• After installing the shear blades, adjust the cutting
depth by referring to the section for cutting depth
adjustment.
Remedy
Charge the battery.
Turn on the tool.
Stop using the tool immediately, and ask your local
authorized service center for repair.
Release the switch trigger and turn off the tool.
Then pull the shear blades straight out slowly from
the branch.
Sharpen the shear blades, and adjust the blade
clearance, and perform cutting depth adjustment.
Replace the shear blades.
• Makita genuine battery and charger
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.