Signal Output; Replace The Battery - PeakTech 5055 Bedienungsanleitung

6. Measuring consideration
1. Please don't keep or operate the instrument at high
temperature & humidity environment for a long period.
2. Keep microphone dry & avoid serious vibration
3. Please select proper measurements range to minimise the
tolerance of readout.
4. Please calibrate the instrument before operate, if the instrument
is not in use for a long time or operate at bad environment.
5. Please don't set Max. Hold (4) during make instrument
calibration.

7. Signal output

The instrument is provided an 3,5 mm phone output terminal for
connection with analyzer, level recorder, tape recorder, control ...
etc.

8. Replace the battery

1. When the LCD display shows "BAT", it indicates a normal
battery output of less than 6,5 V - 7,5 V. It is necessary to
replace the battery. However, in-spec measurement may still be
made for several hours after LOW BATTERY INDICATOR
appears before the instrument become inaccurate.
2. Slide the battery cover away from the instrument and remove
the battery.
3. Replace with 9 V battery and reinstall the cover.
4. Batteries, which are used up dispose duly. Used up batteries
are hazardous and must be given in the for this being supposed
collective container.
-17-