Geberit Selva Betriebsanleitung Seite 19

Replacing the urinal trap
For hygiene reasons, replace the urinal trap
at least once a year.
Prerequisite
– Cleaning mode is activated.
– Refer to figure sequence
while carrying out the instructions.
1
Demount the cover for the urinal
trap.
2
Demount the urinal trap.
3
Replace the urinal trap (art. no.
243.312.00.1) and the cover for the
urinal trap (art. no. 243.314.00.1).
4
Mount the urinal trap.
5
Mount the cover for the urinal trap.
Cleaning or replacing the
basket filter
• Clean the basket filter in the solenoid
valve at least every 2 years or if the flush
volume decreases.
• Descale the basket filter with a commer-
cially available descaling agent if
necessary.
• Replace the basket filter if it can no
longer be completely cleaned and
descaled.
Prerequisite
– Refer to figure sequence
while carrying out the instructions.
1
Demount the urinal flush control. →
See figure sequence
2
Disconnect the cable for the battery
or rechargeable battery
compartment. → See figure
sequence 6 , page 273.
45035999387607819 © 01-2022
970.648.00.0(00)
3
4
5
4 , page 271
6
7
8
9
10
11
Result
✓ The urinal is ready for operation.
Setting the flush time
The flush time can be adjusted to suit the
user's needs using a Geberit app.
Optimising the detection
distance
If flushes are actuated too soon, too late or
5 , page 272
unintentionally, you can optimise the
detection distance of the IR sensor with a
Geberit app.
1 , page 268.
Demount the securing clamp.
Disconnect the solenoid valve and
demount the coupling.
Remove the basket filter.
Clean, descale or replace the basket
filter.
Install the basket filter.
Mount the coupling and snap in the
solenoid valve.
Mount the securing clamp.
Plug in the cable for the battery or
rechargeable battery compartment.
→ See figure sequence
page 273.
Mount the urinal flush control. →
See figure sequence
EN
7 ,
2 , page 269.
19