Geberit Selva Betriebsanleitung Seite 18

EN
Maintenance
Structure of Maintenance
chapter
The accompanying illustration sequences
must be followed while carrying out the
instructions provided in this chapter. Each
set of instructions refers to the accom-
panying illustration sequence.
Caring for and cleaning
smooth surfaces
All smooth surfaces can be cleaned hygien-
ically with water and a mild, liquid cleaning
agent that is kind to the skin.
ATTENTION
Surface damage caused by aggressive
and scouring cleaning agents
▶ Never use cleaning agents that
contain chlorine or which are acidic,
abrasive or corrosive.
Activating cleaning mode
To clean the urinal ceramic and to clean or
replace the urinal trap, the flush actuation
can be suppressed for a few minutes.
▶
Activate cleaning mode with the
Geberit app, Geberit Service Handy
or Geberit Clean Handy.
Result
✓ The flush actuation is suppressed for
10 minutes.
✓ Once these 10 minutes have elapsed, a
flush is actuated.
Notes:
• You can only activate cleaning mode
30 minutes after activating the power
supply or setting the flush time.
18
• The cleaning time of 10 minutes can be
changed with a Geberit app (1–20
minutes).
Cleaning or replacing the
spray head
• Clean the cover for the spray head and
the nozzle with a mild, liquid cleaning
agent at least once a year.
• Descale the nozzle with a commercially
available descaling agent if necessary.
• Replace the nozzle if it can no longer be
completely cleaned and descaled.
Prerequisite
– Refer to figure sequence
while carrying out the instructions.
1
Demount the urinal flush control to
disconnect the water supply. → See
figure sequence
2
Demount the cover for the spray
head.
3
Demount the nozzle.
4
Clean the nozzle and rinse with
water, or replace the nozzle (art. no.
243.333.00.1).
5
Mount the nozzle.
6
Mount the cover for the spray head.
7
Mount the urinal flush control. →
See figure sequence
Result
✓ The urinal is ready for operation.
45035999387607819 © 01-2022
3 , page 270
1 , page 268.
2 , page 269.
970.648.00.0(00)