Hook In Racks; Telescopic Runners; Changing The Oven Light Bulb - KKT KOLBE EB8015ED Benutzerhandbuch

Care and cleaning

Telescopic runners

To clean the side walls of the oven, the telescopic slide rails
can be removed. With a large screwdriver loosen the fastening
screws and remove the complete set.
The telescopic drawer slides do not immerse in water and
do not clean in the dishwasher, but cleaned with standard
cleaning agents outside.
Note: The rollers must not be greased.
!
After cleaning, hook in the telescopic slide rails
and fasten them again at the bottom with the
screws.
Please note:
Telescopic slide rails can not be used with catalytic metal
sheets in the oven!

Changing the oven light bulb

In the lamp bulb is a particularly heat-resistant mold (230 V,
25 W).
To replace this, proceed as follows:
• Disconnect in any case the device from the power
supply (pull the plug or remove the fuse), because the
wording could be live.
• Turn out the glass and replace it with a new of the same
type (see figure at right).
• Screw back the cover glass.
Removing the hook in racks
Remove accessories such as rust and baking sheet.
Hook in racks at the clamping point slightly push down (2 in
figure) and the oven wall down.
Swivel hook in racks inside and unhook at the top (1 in figure)
Inserting the hook in racks
Insert the siderails up in the holes and swing it down.
At the terminal point, push the spine down slightly and press
toward the side wall.
The hook in racks must engage tight.
47