Hitachi P-AP56NAM Installations- Und Betriebshandbuch Seite 25

AIR PANEL P-AP56NAMR
c. While pushing the wiring into the corner pocket, insert
the fixing hooks (2 portions) at
the air panel, and push the receiver kit toward the arrow
A
direction ( ). Then, insert the fixing hook (1 portion) at
B
to the square hole of the air panel.
?
N O T E
Catch securely the fixing hooks of the receiver kit to the air panel.
If not, the fixing hooks will be damaged.
9.4 ELECTRICAL WIRING OF AIR PANEL P-AP56NAMR
Open the electrical box cover at the indoor unit. Connect the connecting cable to the terminal A and B in the electrical box. (No
polarity with terminals A and B)
This receiver kit can be installed to any four corners of the air panel. In the case of installing it to far corner from the electrical box,
run through the wiring for the receiver kit on the fixing plate of the unit between the receiver kit and the electrical box of the unit as
shown.
After running the connecting cable, clamp the extra length of the connecting cable by the plastic band and store it at inside the
ceiling.
Example: installing receiver kit to far corner from electrical box
?
N O T E
If installing the receiver kit near the electrical box, an extra cable shall bind up by the wire clamp.
6 After the installation work for receiver kit is completed, attach the corner pocket covers (3 portions).
17 PMML0570 rev.0 - 01/2021
A
to the square hole of
Indoor unit wiring connection Wire clamp
A
A
Indoor unit
Electrical box
ON
1 2
Air panel
Connecting cable
Fixing
plate
B
Wire clamp
Cable