Beurer TL 90 Gebrauchsanweisung Seite 65

The TL90 is intended for use in the electromagnetic environment specified below. The customer or
the user of the TL90 should ensure that it is used in such an environment.
Immunity test
Radiated RF 3 V/m
IEC 61000-4-3 80 MHz to 2,5 GHz
NOTe 1 At 80 MHz and 800 MHz, the higher frequency range applies.
NOTe 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorpti-
on and reflection from structures, objects and people.
a Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones and land
mobile radios, amateur radio, AM and FM radio broadcast and TV broadcast cannot be predicted theoretically
with accuracy. To assess the electromagnetic environment due to fixed RF transmitters, an electromagne-
tic site survey should be considered. If the measured field strength in the location in which the TL90 is used
exceeds the applicable RF compliance level above, the Medical Daylight should be observed to verify normal
operation. If abnormal performance is observed, additional measures may be necessary, such as reorienting
or relocating the TL90.
b
Over the frequency range 150 kHz to 80 MHz, field strengths should be less than [V1] V/m.
Guidance & Declaration — electromagnetic immunity
Iec 60601 compliance
test level
3 V/m
electromagnetic environment –
level
Portable and mobile RF communications
equipment should be used no closer to any
part of the TL90, including cables, than the
recommended separation distance calcu-
lated from the equation applicable to the
frequency of the transmitter.
Recommended separation distance
3V
d=1.2 P
1/2
d=2.3 P
1/2
where P is the maximum output power rating
of the transmitter in watts (W) according
to the transmitter manufacturer and d is
the recommended separation distance in
metres (m).
Field strengths from fixed RF transmitters,
as determined by an electromagnetic site
a
survey,
level in each frequency range.
Interference may occur in the vicinity of
equipment marked with the following
symbol:
65
guidance
80 MHz to 800 MHz
800 MHz to 2.5 GHz
should be less than the compliance
b