Inhaltsverzeichnis
Werbung
A
SPECIAL COMMANDS
ID-NET™ SPECIAL COMMANDS
The following special command allows to send strings to a Slave (Multidata) #N through the
Master (Multidata) device in an ID-NET™ reading system layout. In order to send this special
command, it is not necessary to switch the reader into Host Mode.
This special command can be used to send
Reading Phase OFF
device in an ID-NET™ reading system layout.
The Matrix 400™ 'Send String To Slave Device #N' special command must have the
following format:
Where:
ADDR:
STRING:
ADDR is a character indicating address of the device in an ID-NET™ Master/Slave reading
system layout:
ADDR = <30
> + <Device Address> where:
H
Device Address = 0:
Device Address = 1 to 31:
Device Address = 32:
This means:
ADDR = <30
>:
H
ADDR = <31
> to <4F
H
ADDR = <50
>
H
strings (for One Shot and Phase Mode operating modes) to a Slave
<ESC> ( <B0
> ADDR STRING ) <ESC>
H
Device Address
String To Send (Length: 1 to 32)
Standalone device or Master ID-NET™ device
Slave ID-NET™ device
ID-NET™ broadcast address
Standalone device or Master ID-NET™ device
>:
Slave ID-NET™ device
H
ID-NET™ broadcast address
Reading Phase
ON,
Acquisition Trigger
and
61
Werbung
Inhaltsverzeichnis
