Troubleshooting - Klarstein AMAZONIA 6 SMART Bedienungsanleitung

TROUBLESHOOTING

Problem
The dishwasher does
not start.
No water is pumped out
of the dishwasher.
Rust stains on the
cutlery.
Coloured stains in the
tub.
Potential cause
The fuse is out or blown.
No power.
The door is not closed
properly.
The drain hose is kinked.
The filter is clogged.
The drain is blocked.
The cutlery is not
stainless.
No programme was
started after the rinsing
salt was refilled.
The lid to the rinsing salt
container is loose.
Coloured detergent.
Solution
Replace the fuse or
flip the switch again.
Remove all other devices
that are connected to
the circuit themselves.
Make sure that the
appliance is switched on,
the door is firmly closed
and the mains cable is
firmly plugged into the
socket.
When closing, make
sure that the door lock
engages.
Check the hose.
Check the coarse filter.
Check your drain and
clean it if necessary. If
you still have problems.
Contact a specialist
company.
Only wash stainless
cutlery.
After filling, start the
quick programme with
an empty dishwasher.
Make sure that the lid is
firmly closed.
Only use detergent
without colour.
EN
69