Display Indications - Klarstein AMAZONIA 6 SMART Bedienungsanleitung

Water hardness
°dH 1) mmol/l 2)
0-5 0-0.9
6-11 1.0-2.0
12-17 2.1-3.0
18-22 3.1-4.0
23-34 4.1-6.1
35-45 6.2-8.0
1) German unit of measurement for water hardness
2) Millimol, international unit for water hardness
3) Each cycle with a regeneration process consumes an additional 2.0 litres of water, the energy
consumption increases by 0.02 kWh and the programme duration is extended by 4 minutes.
* Factory setting
Rinse aid
The rinse aid is released during the final rinse to prevent water droplets from
forming on the dishes, which can leave stains and streaks. It also improves drying
by making the water roll off the dishes. Your dishwasher is designed for the use of
liquid rinse aids.
Only use branded detergents for dishwashers. Never fill other substances (e.g.
dishwasher detergent, liquid detergent) into the rinse aid dispenser. This would
damage the device.
When you need to top up the rinse aid
If the rinse aid warning light (
estimate the amount by looking at the colour of the visual level indicator next to
the lid. When the rinse aid tank is full, the display is completely dark. The size of
the dark spot decreases as the rinse aid decreases. The rinse aid level should never
be less than 1/4 full.
As the rinse aid level decreases, the size of the black dot on the rinse aid level
indicator will change as shown below.
Full 3/4 full
Softener setting
1
2
3 *
4
5
6
) on the control panel is not lit, you can always
1/2 full
Regeneration after
Display
indications
H1 No regeneration
H2
H3
H4
H5
H6
1/4 full Empty
X programme
sequences 3)
10
5
3
2
1
EN
53