eta FENITE Bedienungsanleitung Seite 32

EN
• If you want to limit the epilation surface of the
attachment, put the B2 reduction on attachment B.
by pressing the A1 button twice, select the speed
and place the attachment at a 90° angle. Move it
smoothly over the desired parts. After finishing the
treatment, switch off the appliance.
• When applying to the underarm area, place your
hand behind your head, stretch the skin and
move slowly against the direction of hair growth.
• After use, you can use a soothing moisturizer
or a cooling compress on the treated areas.
b) Shaving attachment C
• The attachment allows you to trim and shave
in one step.
• If the C2 trimming attachment is used, the
appliance is only used for trimming hair.
Switch on the appliance, select the speed and place
the attachment at an angle of approx. 90° with the
shaving blade to the skin, so that long hairs are first
shortened during movement and then immediately
shaved with the shaving blade. Smoothly move the
machine along the desired sections. After finishing
the treatment, switch off the appliance.
IV. MANTENANCE
Clean and maintain after each use. Do not use
harsh and aggressive cleaning agents! Before
maintenance, the machine must be disconnected
from the power supply. Wipe the surface of the
machine A with a soft, damp cloth.
First, remove the attachment B/C from the body of
the epilator A. Then clean the extensions with the
attached brush F. Attachment C1 you can rinse
under slightly running water. Allow the attachment to
dry properly before reinserting it into the body of the
epilator.
Recommendation
EN - 32