Stihl iMOW 5.0 EVO Gebrauchsanleitung Seite 77

10 Installing Guide Wire
2
► Insert the beginning of the guide wire (1) into
the middle conduit (2) and feed the wire
through.
Push the guide wire (1) upward inside the
docking station.
► Feed the guide wire (1) through until it pro‐
trudes upward for a = 37 cm (length:
®
1x iMOW Ruler).
► Using the appropriate cable marker (3), mark
the guide wire (1) near the housing.
Marking will facilitate the subsequent connec‐
tion to the correct terminal.
1
4
► Install the guide wire (1) in the base plate so
that the guide wire lies flat in the cable duct
and is secured by the hook (4).
0458-012-9801-A
1
37 cm (14.5 in.)
27,5 cm (10.75 in.)
a
15 cm (6 in.)
1
3
5
► Attach the guide wire (1) directly at the base
plate (5) with a fixing pin (6).
b
90°
► Route the guide wire (1) for b =2 m in a
straight line and at a right angle (90°) from the
docking station to the mowing area.
► Route the guide wire (1) to the wire loop (7) at
the edge of the mowing area. The distance to
circumferential perimeter wire (8) must be at
least c = 27.5 cm.
c
► Route the guide wire diagonally on inclines.
The distance to the perimeter wire must be at
least c = 27.5 cm.
90°
► Route guide wire (1) for at least e = 37 cm
®
(length: 1x iMOW
at a right angle (90°) to the wire loop (7).
English
1
6
8
1
c
7
c
7
1
Ruler) in a straight line and
77