Intended Use - Dometic ACX3 Serie Kurzbedienungsanleitung

• Do not place the cooling device near naked flames or other heat sources (heaters, direct sunlight,
gas ovens etc.).
• To enable the refrigerant to circulate properly, the cooler may not tilted by more than 3 °. Use a spir-
it level to make sure the cooler is level.
• Ensure that the ventilation openings are not covered.
• Do not fill the inner container with ice or fluids.
• Never immerse the cooling device in water.
• Protect the cooling device and cables against heat and moisture.
• The cooling device shall not be exposed to rain.
• Risk of overheating! Ensure at all times that there is sufficient ventilation on all four sides of the
cooling device. Keep the ventilation area free of any objects that could restrict the air flow to the
cooling components. Do not place the cooling device in closed compartments or areas with none
or minimal air flow.
Note Also observe the following safety instructions:
Fig.  on page 1

4 Intended use

The cooling box is suitable for cooling food. The cooling box is not intended to cool raw meat or raw fish.
The cooling box may be connected to more than one source of energy. The cooling box is designed to be operated
from a 12 V or a 240 V power supply or with gas.
If operated with gas the cooling box may only be operated outdoors. If powered by electricity, the cooling box may
also be operated in enclosed spaces.
The cooling box is also suitable for:
• Use on vehicles
• Camping use
The cooling box is not suitable for:
• Storage of corrosive, caustic or solvent-containing substances
• Freezing of food
This cooling box is not intended to be used as a built-in appliance.
This product is only suitable for the intended purpose and application in accordance with these instructions.
This manual provides information that is necessary for proper installation and/or operation of the product. Poor in-
stallation and/or improper operating or maintenance will result in unsatisfactory performance and a possible failure.
The manufacturer accepts no liability for any injury or damage to the product resulting from:
• Incorrect assembly or connection, including excess voltage
• Incorrect maintenance or use of spare parts other than original spare parts provided by the manufacturer
• Alterations to the product without express permission from the manufacturer
Fig.  on page 1 Fig.  on page 1 Fig.  on page 2
EN
11