First Flight Preparation; Flying Checklist; Installing The Dxs Transmitter Batteries (Rtf); Dxs Transmitter Control (Rtf) - Horizon Hobby BLADE 330S Bedienungsanleitung

First Flight Preparation

• Remove and inspect contents
• Begin charging the flight battery
• Install the flight battery in the helicopter (once it has been fully charged)
• Program your computer transmitter
• Bind your transmitter (BNF only)
• Familiarize yourself with the controls
• Find a suitable area for flying

Installing the DXS Transmitter Batteries (RTF)

The LED indicator flashes and the transmitter beeps progressively faster as the
battery voltage drops.
Replace the transmitter batteries when the transmitter begins to beep.
CAUTION: NEVER remove the transmitter batteries while the model is
powered on. Loss of model control, damage or injury may occur.
CAUTION: If using rechargeable batteries, charge only rechargeable
batteries. Charging non-rechargeable batteries may cause the batteries
to burst, resulting in injury to persons and/or damage to property.
CAUTION: Risk of explosion if battery is replaced with an incorrect type.
Dispose of used batteries according to national regulations.

DXS Transmitter Control (RTF)

Aileron (Left/Right)
Mode 1
Throttle (Up/Down)
Aileron (Left/Right)
Mode 2
Elevator (Up/Down)
Bind/Panic Switch
Fli ght Mode Switch
Flight Battery level Indicator
Battery Voltage Level
The included DXS transmitter includes a new flight battery voltage level indicator
feature.
LED Smart Battery voltage indication is based on current voltage and will change
with throttle/power usage. When throttle is increased, voltage drops, causing the
bars to indicate lower power (e.g., fewer LEDs solid or flashing.) When the throttle
is lowered to idle/off, the bars recover (e.g., more LEDs solid or flashing). LED bars
will rise and lower depending on throttle/power usage.
The Smart Battery low voltage alarm sounds when the ESCs are close to reaching
low voltage cutoff. The alarm will sound for 25 seconds. If the throttle is lowered to
allow voltage recovery, the alarm will stop early. Land the aircraft when the alarm
sounds.
After landing, reset the Smart Battery low voltage warning by either (1) powering
cycling the DXS transmitter, or (2) disconnecting the battery from the aircraft for
more than 15 seconds or until the LED voltage indication bars go out.
Connect a fully charged battery to the aircraft, which will ensure the Smart Battery
low voltage warning resets prior to the next flight.
EN
A B
Throttle Trim Aileron Trim
Elevator Trim Aileron Trim
0 = Stability Mode (NORM)
1 = Intermediate Mode (FM1)
2 = Agility Mode (FM2)
LED Indicator
G
F
E

Flying Checklist

❏ Always turn the transmitter on first
❏ Plug the flight battery into the lead from the ESC
❏ Allow the ESC to initialize and arm properly
❏ Fly the model
❏ Land the model
❏ Unplug the flight battery from the ESC
❏ Always turn the transmitter off last
C D
ON/OFF Switch Rudder Trim
ON/OFF Switch Rudder Trim
4
E F
Rudder (Left/Right)
Elevator Trim
Elevator (Up/Down)
Rudder (Left/Right)
Throttle Trim
Throttle (Up/Down)
Throttle Hold
Du al Rate Switch
A
B
C
D
G