Elica Aria nuova Montage- Und Gebrauchsanweisungen Seite 13

Note: after resetting the hob type, to a type other than the
Default one or the previous one, an automatic calibration of
the VOC sensor will start. See the chapter on this function.
CONTROLLING THE PRODUCT VIA WI-FI
The are two product control modes via Wi-Fi; to do this, it is
necessary to download the Elica Connect App and follow
the instructions given.
• Elica Cloud mode
This feature allows the product to be controlled from a
mobile device, even when away from home.
• Direct Control mode
This feature allows the product to be controlled from a
mobile device, as if it were the Radio Control.
● Wi-Fi configuration:
Follow the instructions provided in the Elica Connect App
for the Wi-Fi configuration. During the configuration
procedure, LED L2 will light up indicating the connectivity
status (see the Wi-Fi status table below). To interrupt the
Wi-Fi configuration procedure, press key A on the Radio
Control for about 2 sec. when LED L2 on the hood is lit up
and is flashing fast.
● Wi-Fi configuration reset:
This operation is used to reset the product to the factory
configuration.
With Radio Control 1:
press keys A+B for 2 sec.
With Radio Control 2:
press keys D+E for 2 sec.
Note: The password and all other settings made from the
Elica Connect App will be reset and will need to be set
again.
● Wi-Fi On/Off:
After the configuration, the Wi-Fi can be switched on / off.
With Radio Control 1:
Press key A for 2 sec.
With Radio Control 2:
This procedure is described in the Radio Control manual.
Note: Switching off the Wi-Fi with this procedure does not
result in the loss of the previously saved parameters.
WI-FI STATUS TABLE
LED L2 Wi-Fi Status
Light off WiFi not configured or off
Steady white
WiFi connected
light
Fast flashing
Attempt to connect to the WiFi
router
orange light
Slow flashing
orange light
White light on
with brief flashing
Steady orange light
MAINTENANCE WARNINGS
• Cleaning: For cleaning, simply use a cloth moistened
with neutral liquid detergents. Do not use cleaning tools or
instruments.
• Avoid the use of abrasive products. DO NOT USE
ALCOHOL!
For product maintenance, see the images at the end
of the installation marked by this symbol.
• Anti-Grease Filter: The metallic anti-grease filter
must be cleaned once a month with non-aggressive de-
tergents, manually or in a dishwasher on a short wash at
low temperatures. To remove the anti-grease filter, pull
the spring release handle.
• The Anti-Grease Filter traps the grease particles
produced during cooking. When cleaned in the dishwasher,
the metal grease filter may discolour, but its filtering
characteristics remain unchanged.
• Perimeter suction panel: The perimeter suction
panel should always be left closed and should only be
opened in case of maintenance (e.g. cleaning or repla-
cing the filters).
Illumination
• Lighting system : The lighting system cannot be repla-
ced by the user, contact Customer Service in case of
malfunction.
• The lighting system is based on LED technology. LEDs
provide optimal illumination, last up to 10 times longer than
conventional lamps and save 90% of electricity.
DE
Das Produkt ist für die Absaugung von Kochdämpfen
konzipiert und nur für den Hausgebrauch bestimmt.
Die in diesem Handbuch aufgeführten Anleitungen
müssen streng eingehalten werden. Es wird keine
Haftung für eventuelle Unannehmlichkeiten, Schäden oder
Brände am Produkt übernommen, die durch die
Nichtbeachtung der in diesem Handbuch angeführten
Anleitungen entstehen.
Das Gerät kann von den Zeichnungen in dieser
Broschüre abweichen, die Gebrauchs-, Wartungs- und
Installationsanweisungen bleiben jedoch unverändert.
• Es ist wichtig, alle dem Produkt beiliegenden Handbücher
aufzubewahren, damit sie zu jedem Zeitpunkt eingesehen
13
Attempt to connect to the Elica
Cloud (in Cloud mode)
Remote command being recei-
ved: motor on or light on, etc.
Direct mode with App temporarily
disconnected. (in Direct mode)