Wiring; Commissioning - SOMFY S&SO-RS100 AIR io Anleitung

EN

2.2. WIRING

Attention
• Cables which pass through a metal wall must be protected and isolated using a sheath or
sleeve.
• Attach cables to prevent any contact with moving parts.
• If the drive is used outdoors, and if the power supply cable is a type H05-VVF cable, the cable
should be installed in a UV-resistant duct, e.g. under a duct.
• The cable of the S&SO-RS100 AIR io can be removed. If it becomes damaged, replace it with
an identical cable.
• Leave the drive power supply cable accessible: it must be easy to replace.
• Always make a loop in the power supply cable to prevent water entering the drive!
• The S&SO-RS100 AIR io is a Category II drive and has no earth wire.
- Switch off the power supply.
- Connect the drive according to the information in the
table below:
Cable
Blue
N
Brown
L

2.3. COMMISSIONING

These instructions describe commissioning using a Somfy io-homecontrol® local control point.
A Somfy io-homecontrol® local control point is a one-way radio transmitter
͉
͉
For certain specific control points, the procedure may be different. Refer to the corresponding control
point instructions.
Identifying the steps to follow
The settings for the end limits depend on the type of roller shutter:
16
230 V 50 Hz
Neutral
Live
Copyright © 2019 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
OFF
230 V 50 Hz
L
N
N
L
.
S&SO-RS100 AIR io