Installation; Motor Preparation; Preparing The Tube; Motor/Tube Assembly - Somfy Oximo Rts Gebrauchsanleitung

Oximo RTS

3. Installation

3.1 Motor preparation

1) Fit the crown (A) and the drive wheel (B) to the motor.
2) Measure the length (L1) between the motor head and the
end of the drive wheel.

3.2 Preparing the tube

1) Cut the roller tube to the required length.
2) Deburr the roller tube and remove the swarf.
3) For smooth roller tubes, cut a notch with the following
measurements:
- e = 4 mm
- h = 28 mm

3.3 Motor/tube assembly

1) Slide the motor into the roller tube.
For smooth roller tubes, position the notch previously cut
on the crown.
2) Fix the roller tube to the drive wheel with 4 x Ø 5 mm
self-tapping screws or 4 steel pop rivets of Ø 4.8 mm
located:
- at least 5 mm from the far end of the drive wheel:
L1 - 5, and
- no more than 15 mm from the far end of the drive
wheel.
Caution! The screws or pop rivets must only be attached to
the drive wheel and not to the motor.

3.4 Fitting the tube/motor assembly

1) Fit the tube/motor assembly to the end bracket (C).
Fit the tube/motor assembly to the motor bracket (D).
2) Fit the stop ring (E).

3.5 Wiring

- Cut off the mains power supply.
- Connect the motor according to the information in the
table below:
230 V
50 Hz ~
1 Brown Black
2 Blue White
3 Yellow/Green Green
46
120 V
Wire
60 Hz ~
Live (P)
Neutral (N)
Earth ( )
1
2
1
3
1
2
1
D
2
E
OFF
230 V
50 Hz
~
3 x 1.5 mm
Copyright © 2008-2009 Somfy SAS. All rights reserved.
B
A
L1 = ...
L1
2
Ø > 47
h
e
15 mm
5 mm
L1 20 mm
C
3 x 0.75 mm 2
1
2
3
2
1
2
3