Wiring - SOMFY RU Basic 28 WF RTS Li-ion II Anleitung

EN
2.1.3.Assembling the drive-tube
1] Slide the drive into the tube. Insert the
wheel by aligning the wheel to the tube
profile. Insert the drive half way and then
slide the crown down the drive and insert
it in the tube. Finally, push the motor
inside the tube.
2] Not required, but if needed, fix the tube to
the drive with self-tapping screws or steel
pop rivets depending on the dimension (L).
2.1.4.Mounting the tube-drive assembly on the brackets
(a) Standard bracket.
(b) Drive plate for specific bracket.
NOTICE
For optimal radio reception, the motor antenna should be kept straight and
should be positioned outside of headrail (if used).

2.2.Wiring

WARNING
• To ensure electrical safety, this Class III drive must be powered by a «SELV»
voltage source (Safety Extra Low Voltage).
• Improper using battery pack may cause overheat, fire, explosion, resulting in
serious injury or death.
6
©
Copyright 2021 SOMFY ACTIVITES SA. All rights reserved.
RU Basic 28 WF RTS Li-ion II
1]
2]
(a) (b)