Preliminary Information; Field Of Application; Liability; Installation - SOMFY S&SO-RS100 AIR io Anleitung

EN

1. PRELIMINARY INFORMATION

1.1. FIELD OF APPLICATION

The S&SO-RS100 AIR drives are designed exclusively to drive roller shutters equipped with rigid
links and a kit enabling the Ventilated Locked Shutter function to be performed.
The professional drive and home automation installer must ensure that, once installed, the
installation of the motorised product complies with the standards in force in the country in which it is
commissioned such as, for example, the EN13659 roller shutters standard.

1.2. LIABILITY

Please read these instructions carefully before installing and using the drive. In addition to following
the instructions given in this guide, the instructions provided in the attached Safety instructions
document must also be observed.
The drive must be installed by a home drive and automation professional, in accordance with
Somfy's instructions and the applicable regulations in the country of installation.
Any operation of the drive outside the field of application described above is prohibited. Such use, and
any failure to comply with the instructions given in this guide and in the attached Safety instructions
document, absolves Somfy of any liability and invalidates the warranty.
The installer must inform its customers of the operating and maintenance conditions for the drive
and must provide them with the operating and maintenance instructions, and the attached Safety
instructions document, after installing the drive. Any After-Sales Service operation on the drive must
be performed by a drive and home automation professional.
Should any doubt arise during installation of the drive or for additional information, consult a Somfy
representative or visit www.somfy.com.

2. INSTALLATION

Warning
• These instructions are mandatory for the drive and home automation professional installing
the drive.
• Comply with current standards and legislation in the country of installation.
Attention
• Never drop, knock or puncture the drive or immerse it in liquid.
• Install an individual control point for each drive.

2.1. ASSEMBLY

2.1.1. Preparing the drive installation
1) Fit the accessories required to integrate the drive in the
roller tube:
• Either fit the drive wheel
• Or fit the crown
drive.
2) Measure the length (L) between the inner edge of the
drive head and the outer edge of the drive wheel.
14
a on the drive.
b
and the drive wheel
Copyright
1)
Ø = 47 mm
c
on the
2)
© 2019 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
S&SO-RS100 AIR io
Ø > 47 mm
a b c
L = ...
L