Force Reduction - struers RotoForce-1 Gebrauchsanweisung

16
RotoForce-1
Instruction Manual

1. Force Reduction

RotoForce-1 is equipped for automatic reduction of the force
towards the end of the preparation.
If FORCE REDUCTION is enabled, the force will automatically
be reduced to 50% of the pre-set value for the last third of the
preparation step. This will result in lower material removal and
smaller scratches than usual. The time for the subsequent
preparation steps can be reduced as the amount of damaged
material to be removed will be reduced.
30N 04:00
STOP
,
m
,
FORCE REDUCTION
NO
, 7
L L
, 7
FORCE REDUCTION
YES
,
o
,
30N 04:00
STOP
m
Press MENU until you reach the
FORCE REDUCTION screen.
L
Press SELECT to toggle between
NO and YES.
o
Press STOP to accept the choice.
Operation Menu will appear again.