Running A Preparation Method; Using A Specimen Mover Plate; Using The Specimen Holder; Adjusting The Force - struers RotoForce-1 Gebrauchsanweisung

Running a Preparation Method

Using a Specimen Mover Plate

Using the Specimen Holder

Adjusting the Force

Adjusting the Preparation Time

12
RotoForce-1
Instruction Manual
n Move RotoForce-1 into the upright position.
n Remove the three screws securing the mover plate or slide
the specimen holder off the legs.
n Put a specimen mover plate in position and secure it with the
three screws.
n Move RotoForce-1 into the upright position.
n Remove the three screws securing the specimen mover plate.
n Slide the specimen holder evenly onto the three legs.
n Insert the correct preparation disc and press RotoForce-1
down into the correct position.
fO
Press FORCE or
30N 01:00
STOP
,
fO
,
35N 01:00
STOP
The force displayed is the force applied per specimen. Also when
working with the specimen holder ROFLU, as the three pressure
feet will transfer the force to the specimen holder where three
specimens are clamped. It is not necessary to apply higher forces.
tO
Press TIME or
35N 01:00
STOP
,
tO
,
35N 01:10
STOP
fN
to adjust the force to the desired value.
tN
to adjust the preparation time.