Atlantic SOLIUS DIGITAL Bedienungsanleitung Seite 19

Problem encountered
The appliance does
not heat up enough.
The surface of the
appliance is very hot.
Traces of dirt appear
on the wall around the
appliance.
The appliance does
not follow the internal
programming
commands.
The screen shows
The screen shows
The screen shows
Increase the temperature.
If the ambient temperature of the room does not reach the requested
temperature, read the temperature at the bottom right of the appliance
(this is where the sensor is located). If this temperature is above the set
temperature, then the appliance should not be heating up. If there is a
notable difference between the temperature at the bottom right of the
appliance and the ambient temperature of the room, we recommend that
you correct the environment around the appliance. Otherwise, we would
ask that you check that the power of the appliance is correct for the
dimensions of the room and your structure. Also ensure that the product
is heating an enclosed area.
It is normal that the appliance is hot when operating and the maximum
surface temperature is limited in accordance with the NF Electricity
standard. If, however, you feel that your appliance is always very hot, check
the ambient temperature of the room. If this is higher than the set
temperature, refer to the section "The appliance is heating constantly".
Otherwise, the appliance is heating to the correct power for its output and
the dimensions of the room.
In a polluted atmosphere, dirt may appear around the appliance's air
outlets or on the wall. This phenomenon is linked to the poor ambient air
quality (cigarette smoke, candles, incense, fireplace, etc.). In this case, you
are advised to check that the room is suitably ventilated (ventilation, air
intake, etc.).
Check that the date and time are set.
Check that the appliance is in Programming mode.
This symbol is displayed when an open window is detected.
This symbol is displayed when the appliance is overheating. Contact the
After-Sales service.
This symbol is displayed when the appliance sensor is defective. Contact
the After-Sales service.
Checks to carry out
19