Maximum Temperature; Heating Standby Indicator; Factory Settings - Atlantic SOLIUS DIGITAL Bedienungsanleitung

The appliance can save a maximum temperature (of between 19 °C and 28 °C), which the settings
cannot exceed. By default, it is set to 28 °C.
1 - Press and hold the
.
2 - Press to display
3 - Press ;
4 - Set the new value using the
5 - Press to exit.
Example: I want to prevent a temperature above 24 °C from being set.
There is an automatic inactivity timeout on the control panel display after a few seconds, with the
exception of the heating indicator, which is lit when the resistor power supply is on. It is possible to
configure the panel so that the indicator goes out when the panel display is switched off.
1 - Press and hold the
.
2 - Press twice to display
3 - Press , will flash alternately with
4 - Press to display
5 - Press to exit.
It is possible to reset the appliance, erasing all the settings made (programs, calibration, maximum
temperature, heating indicator). This function is particularly useful in case of programming errors.
1 - Press and hold the
.
2 - Press three times to display
3 - Press ,
4 - Press to display
5 - Press to confirm. All the indicators will light up. The appliance will then return to Comfort
mode at 19 °C.

MAXIMUM TEMPERATURE

and buttons at the same time for more than 3 seconds to display
(Max. Temperature).
will flash alternately with the currently set maximum temperature
buttons (between 19 °C and 28 °C).

HEATING STANDBY INDICATOR

and buttons at the same time for more than 3 seconds to display
(Heating Indicator).
.

FACTORY SETTINGS

and buttons at the same time for more than 3 seconds to display
will flash alternately with
.
.
(Factory Settings).
.
17
.