Advanced Settings - Atag ENERGION Bedienungsanleitung

User Menu
Standby settings
Brightness in standby
Standby timing
Screen saver selection
– "OFF": displays the selected home page.
– "Room T": displays the current room temperature.

Advanced settings

CH SETTINGS
Advanced settings
CH settings
Cooling settings
AUTO function
Buffer
Heat Pump
System measurement unit
– "CH setpoint temperature": in the menu you can set the
water temperature set-point in heating mode for each hy-
draulic zone present in the system. The menu can be used
to:
– adjust the temperature set-point if the automatic
temperature control function ("AUTO function") is
disabled.
– apply a correction to the temperature set-point
using a slider, if the automatic temperature control
function ("AUTO function") is active and the water
temperature does not match the desired temper-
ature.
OFF
70%
Room T
1 min
Fig. 59
– "Set curve slope": if the automatic temperature control
>
>
ON
>
>
International
system
Fig. 60
T set Z1
- 0°C
Push Ok to confirm
function ("AUTO function") is active, the slider can be used
to change the slope of the climate curve. Consult the man-
ual of the heat generator installed in the system for further
information.
Zone 1 parameters
T set Z1
Set curve slope
Set curve slope
- 1,5
Push Ok to confirm
+
Fig. 61
>
>
Fig. 62
+
Fig. 63
63 / EN