Fireplace; Connectivity - Atag ENERGION Bedienungsanleitung

User Menu
THERMAL CLEANSE FUNCTION
Thermal cleanse function
Thermal cleanse function
Thermal Cleanse Cycle frequency
Thermal Cleanse start time [hh:mm]
– "Thermal cleanse function": enables/disables the ther-
mal sanitisation of the DHW cylinder.
– "Thermal Cleanse Cycle frequency" (where availa-
ble): sets the frequency of the sanitisation cycle (24 hours
- 30 days).
– "Thermal Cleanse start time [hh:mm]" (where avail-
able): sets the start time for the thermal sanitisation cycle.
If the thermal sanitisation cycle is not complet-
a
ed within the scheduled time, it will be repeat-
ed on the following day at the specified time.

Fireplace

It adjusts the request for heat in the zone associated with the
device based on the outdoor temperature until the selected
time.
When the function is active, the indoor temperature of the
room does not affect the request for heat.
Refer to the paragraph "Automatic winter mode".
In order to enable the function, an outdoor temperature sen-
sor must be fitted in the system or, if available, the Internet
weather report must be active (refer to the "Connectivity" par-
agraph).

Connectivity

Connectivity
OFF
30 days
01:00
Fig. 46
– "ON/OFF Wi-Fi Network": Enables/disables the Wi-Fi
module connected to the system
– "Network configuration": Enables the configuration of
the Wi-Fi module present in the system. Read the product
instructions for further information.
– "Serial number": Displays the serial number of the Wi-Fi
device installed.
– "Reconfiguration": Restores the factory settings of the
Wi-Fi device.
– "Signal Level": Displays the Wi-Fi signal strength on a
scale from 0 to 100.
– "Internet Time": Enables the acquisition of the system's
time from the Internet
– "Internet weather": Enables the acquisition of the out-
door temperature and the weather conditions from the
Internet
ON/OFF Wi-Fi Network
Network configuration
Serial number
Reconfiguration
Signal Level
Internet Time
ON
>
>
>
0%
ON
Fig. 47
59 / EN