Technical Data; Optimising The Flow Rate; Declaration Of Conformity - Kärcher SP 16.000 Dirt Bedienungsanleitung

Fault
The pump is running, but
not delivering
The pump does not start
up, or stops suddenly
during operation
The pumping capacity
decreases
The delivery rate is too
low
Quick-Connect cannot
be opened or closed

Technical data

Device performance data
Mains voltage
Power frequency
Nominal power
Maximum flow rate
Pressure (max.)
Delivery height (max.)
Immersion depth (max.)
Perm. temp. feed fluid
Particle size (max.) of per-
missible feed fluids
Minimum fluid level (manu-
al mode)
Residual fluid height
Weight (without accesso-
ries)
Subject to technical modifications.
12
Cause
Air is in the pump.
The suction area is clogged.
The fluid level is too low in manual oper-
ation.
The power supply is disconnected.
The thermal protection switch has
switched off the pump because of over-
heating.
Dirt particles block the suction area.
The suction area is clogged.
The maximum delivery head is exceed-
ed.
The hose diameter and the hose length
have been selected incorrectly.
The push-fit system is dirty.
SP SP
16.000 22.000
Dirt Dirt
V 230-240 230-240
Hz 50 50
W 550 750
l/h 16.000 22.000
MPa 0,08 0,08
(bar) (0,8) (0,8)
m 8 8
m 7 7
°C 5...35 5...35
mm 20 30
mm 60 50
mm 25 35
kg 4,9 6,5
Rectification
1. Pull the mains plug out of the socket and
plug it in again several times, until the fluid
is drawn in.
1. Pull the mains plug out of the socket.
2. Clean the suction area.
1. Immerse the pump deeper into the feed flu-
id if possible, see chapter Operation.
1. Check the fuses and the electrical connec-
tions.
1. Pull the mains plug out of the socket.
2. Allow the pump to cool down.
3. Remove any dirt particles in the suction ar-
ea.
4. Clean the suction area.
5. Prevent the pump from running dry.
1. Pull the mains plug out of the socket.
2. Clean the suction area.
1. Pull the mains plug out of the socket.
2. Clean the suction area.
1. Observe the maximum delivery head, see
chapter Technical data.
2. If necessary, select a greater hose diame-
ter or a shorter hose length, see chapter

Optimising the flow rate.

1. Remove the clip.
2. Clean the clip.
3. Install the clip.
Optimising the flow rate
The flow rate is further increased:
● The lifting height is reduced.
● The diameter of the hose used is increased.
● The length of the hose used is decreased.
● The smaller the pressure loss caused by the con-
nected up accessories.

Declaration of Conformity

EU Declaration of Conformity
We hereby declare that the machine described below
complies with the relevant basic safety and health re-
quirements in the EU Directives, both in its basic design
and construction as well as in the version placed in cir-
culation by us. This declaration is invalidated by any
changes made to the machine that are not approved by
us.
Product: Pump
Type: 1.645-xxx
English