A
B
C
4. Locate the terminal (D) of the illuminant connection cable (E) in the junction box
and disconnect it (s. fig. below).
D
E
5. Carefully press the spring clips (F) on both sides of the LED illuminant (G) inwards
using your hand (s. fig below on the left). Simultaneously push the LED illuminant
(G) downwards out of its holder (H / s. fig. below on the right). You can also use a
flathead screwdriver for this purpose (s. fig. below on the left). Be very careful when
doing this.
6. Then carefully pull out the illuminant connection cable (E) slightly (s. fig. below on
the right).
C
OVER OF THE JUNCTION BOX
S
T
ERMINAL OF THE ILLUMINANT CONNECTION CABLE
I
LLUMINANT CONNECTION CABLE
J
UNCTION BOX
ECURING PLATE
79