8 . S Y S T E M M A L F U N C T I O N S / D E B U G G I N G
8 . 1 .
S p e c i a l s a f e t y i n s t r u c t i o n s f o r d e b u g g i n g
DANGER, RISK OF ELECTRIC SHOCK
1. Make sure the power supply unit is disconnected from mains
each time before performing work on the unit or the connected
application. Dangerous voltage may crop up from residual charge
even after the unit is switched off.
2. The unit may only be opened by instructed technicians. Please
observe the warranty terms.
8 . 2 .
S e r v i c e a d d r e s s
Maintenance and repairs are carried out directly by the manufacturer. Please
contact
Heinzinger electronic GmbH
Anton-Jakob-Str. 4
83026 Rosenheim / Germany
8 . 3 .
I n t e g r a t e d f u s e s
The unit is equipped with fuses on the primary side (back of unit) and at the
power amplifier (inside the unit). If these fuses are blown, there could be a defect
in the unit. In such a case please get in contact with the manufacturer.
Phone +49 8031 2458 0
Fax
+49 8031 2458 58
info@heinzinger.de
User Manual PNC – V 1.16
65