Transport; Installation Site; Installation Position; Minimum Clearances - STIEBEL ELTRON LWF AP 1.5 Bedienung Und Installation

INSTALLATIoN
Installation
8.1

Transport

Material losses
!
during transportation, ensure that you do not subject
the connection pipes to any stresses. Never lift the ap-
pliance by the connection pipes.

8.2 Installation site

8.2.1 Installation position

When installing the appliance, you can select which side to
have the air intake on.

8.2.2 Minimum clearances

distance from other components of the air duct system
(e.g. bends) and from the ventilation unit
Wall mounting
≥100
LWF AP 1.5
mm 500
≥100
Ceiling mounting
≥100

8.3 Profile rails

f Reach into the recesses on the sides of the appliance.
f Pull off the front cover.
8.3.1 Fitting the profile rails to the wall or ceiling
To prevent slippage, the side ends of two of the profile rails
are bent.
f Secure these profile rails below the ceiling or to the wall.
Use suitable fixing materials in all drill holes. The precise
positioning can be found in the dimensioned drawing for
the appliance.
Ceiling mounting
Wall mounting
If the clearance from the wall is greater at the top than at the
bottom, slide the supplied washers between the lower profile
rails to act as spacers.
≥100
| 15