Herunterladen Inhalt Inhalt Diese Seite drucken

Grundig GDSP2470BSCH Bedienungsanleitung Seite 17

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

5
Installation of appliance
• The bolts and dowels provided are suitable for
brick walls. For other construction material (e.g.
drywall, plate, porous concrete), suitable fixing
dowels and nuts shall be used.
(Figure 2)
CAUTION: Before drilling, ensure
A
that there are no power, gas or wa-
ter pipes in the close proximity of the
drilling locations.
Draw a mid location line from the ceiling perpendi-
cular to the lower edge of the hood.
Paste the installing template provided within the
accessories on the surface where the hood is to
be mounted. In doing this operation, observe the
mounting height of the hood.
There is a tab in the middle of the flue connection
plate. Place the middle point of this tab on the line
that is drawn perpendicular to the wall. In doing
this operation, adjust the hood according to the
maximum height (Figure 1). Mark the holes where
the flue connection plate will be mounted with the
help of a pen (Figure 2/a).
Drill the marked points with Ø6mm drill and insert
2 plastic dowels in the drilled holes (Figure 2/a). Fix
the flue connection plate to the wall with 3,9x22
screws (Figure 2/a).
Cooker Hood / User Manual
To assemble the hood body, you can use the A,
B, C, D Ø10 mm drill on the assembly template,
and insert Ø10 mm plastic dowels at these points.
(Figure 2/b).
2 piece 5.5x60 suspension screw with a clearance
of 5 mm between the screw head and the wall
(Figure 2/b).
(Figure 3)
Ø10mm
1. Hanger plate
Ø5,5x60
2. Hanging plate connection screw
In order to install your hood to the wall, loosen the
screws on the hanger plates mounted on the mo-
tor cabin and pull them up, and then fasten again
(Figure 3/A).
Turn on the suction glass of the hood and remove
the aluminum oil filter.
Ø4,8x50mm
(Figure 4)
Hold the cooker hood by its body and place it on
the mounting screws on the wall and tighten the
screws (Figure 4). Secure the cooker hood with
two 5.5x60 screws to the wall through the moun-
ting hole on the interior of the appliance (Figure 4).
17 / EN

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis