LAVAZZA blue CLASSY CUSTOM MILK Bedienungsanleitung Seite 64

EN
N° Problem encountered
The machine will not be
switched on when the ON/
1
STAND-BY
button is pressed.
Excessive heating time
2 perceived (more than 40
seconds).
3 The machine is very noisy.
Unit ready for use and failing
4 to acknowledge the button
press.
64
TROUBLESHOOTING
Possible causes
1 - Machine is not connect to
the power source.
2 - T he machine is connected
to broken multiple sockets
or power strip
3 - Touch interface fails to
respond.
4 - W rong simultaneous
pressure of 2 buttons.
5- Power supply not available
in the electric/household
mains.
1 - Machine storage at low
temperatures
(ex.: cellar/garage).
2 - Presence of limescale.
1 - M achine not is on a flat
and stable surface.
2 - Power supply cable
incorrectly positioned.
3 - Movable parts not fitted
properly
4 - No water in the tank.
5 - C apsule not present.
1 - Wrong button press/
activation.
2 - U sed capsule collection
tray inserted incorrectly.
Solution
Connect the machine to the
power source
Connect the machine directly to
the power source.
Verify that the interface surface
and the user's hands are clean
and dry.
Wait a few seconds, then press
the ON/STAND-BY
button only.
Connect another device to
check the power supply.
Keep the machine in a suitable
place over at least 1 hour.
Then, plug the machine into the
mains socket and try to switch
it on.
Perform the descaling procedure
by means of the Lavazza
descaling agent.
Check the surface.
Check the correct position of
the cable into the base of the
machine.
Fit the movable parts properly.
Top up the tank with fresh
drinking water.
» Insert Lavazza
capsule or compatible.
Press one of the illuminated
buttons with your fingertip,
then check the availability of the
acoustic signal (if activated)
and the proper blinking of the
selected icon.
Verify that the tray has been
inserted correctly and the
alarm warning light is switched
off accordingly, then start the
supplying phase.
Result
OK: call solved
Non-ok: go to step 2
OK: call solved
Non-ok: go to step 3
OK: call solved
Non-ok: go to step 4
OK: call solved
Non-ok: go to step 5
Ok: machine being serviced.
Non-ok: electric system fault.
OK: call solved
Non-ok: go to step2
OK: call solved.
Non-ok: machine being serviced.
OK: call solved
Non-ok: go to step 2
OK: call solved
Non-ok: go to step 3
OK: call solved
Non-ok: go to step 4
OK: call solved
Non-ok: go to step 5
OK: call solved
Non-ok: machine being serviced.
OK: call solved
Non-ok: go to step 2
OK: call solved
Non-ok: machine being
serviced.