Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
what you are doing. Always proceed with
caution and do not assemble the lamp if you
cannot concentrate or feel unwell.
Preparation
Q
Required tools and materials
Q
The tools and materials mentioned are not included
in the delivery. The details and values given are
non-binding and for guidance only. The nature of
the material depends on the individual circumstanc-
es on site.
- Pencil / Marking tool
- Screwdriver
- Electric drill
- Drill bit
- Spirit level
Preparations for use
Q
Mounting the light
Q
1. Measure up the wall or mounting surface for
drilling the holes. Use a spirit level to improve
accuracy.
2. Mark the two mounting holes a distance of
approx. 41 cm apart.
3. Now drill the mounting hole (ø 6 mm). Make
sure that you do not damage any electrical
cables during this operation.
4. Insert the supplied dowels into the drilled holes.
Insert the supplied screws into the dowels and
tighten them.
5. Attach the light using the appropriate mounting
holes
or
to the screws.
4
8
6. Insert the light connector plug of the power supply
cable
into the light connector socket
12
7. Insert the mains plug of the power supply
cable
into a convenient mains socket. Your
12
light is now ready for operation.
6
GB
Connecting several
Q
lights together
CaUTIOn! Make sure that all under-cabinet lights
are linked together by means of the connecting
cables
before inserting the mains plug of the
7
power supply cable
note: Make sure that you only connect a maximum
of 10 linked-up under-cabinet lights of the same
type to one socket.
1. Install up to 10 lights of the same model next
to each other. To do so, follow steps 1 – 5 of
the section called "Mounting the light".
note: Make sure that the distance between
the lights is not more than 24 cm.
2. Remove the protective head guard
unscrewing the screw.
3. Insert the connecting cable
necting socket
4. Insert the second connection of the connecting
cable
7
5. Insert the connection of the power supply
cable
12
6. Insert the the mains plug of the power supply
cable
12
ready to use.
Switching On / Off
Q
j
S witch the ON / OFF switch
on or off.
Directing the light
Q
j
N ever change the direction of the light while it
is switched on.
C aUTIOn! DangER OF bURnS! Do not
.
touch bulb components or bulbs as they can
1
reach temperatures higher than 90 °C during
operation.
j
A llow the light to cool down completely.
j
T urn the strip light
The strip light can pivot through approx. 80°
when mounted under a cabinet (mounting
into the socket.
12
into the con-
7
of the light.
5
into the socket
of the other light.
1
into the socket
of the first light.
1
into the socket. Your light is now
to turn the light
2
into the desired direction.
9
by
6
Werbung
Inhaltsverzeichnis
