Preparation; Required Tools And Material; Prior To Installation - LIVARNO LUX IAN 333239_1910 Montage-, Bedienungs- Und Sicherheitshinweise

Safety / Preparation / Installation
The manufacturer accepts no responsibility for
an inappropriate wall plug connection and any
resulting damage.
This light is not suitable for dimmer
or electronic switches.
Risk of burns and injury!
Do not install the light, if it has a defective lamp
glass. In this case contact the service centre for
a replacement.
Only install the light on normally inflammable
or non-inflammable surfaces. Excessive heat can
result in a fire.
Never open any of the electrical equipment or
insert objects into these. This will pose the risk
of fatal injury from electric shock.
To prevent burns, ensure that the light is switched
off and has cooled down before touching it.
Lamps become very hot.
Do not look directly into the light source (light
bulb, LED etc.).
Only use the individual parts supplied, other-
wise all warranty claims will become invalid.
Do not use optical instruments to look at the
light source (e.g. magnifier).
This lamp's illuminant is not replaceable; if the
illuminant has reached the end of its service
life, the whole light must be replaced.
Safe working
The outdoor light is splash-proof.
Always be attentive! Always pay attention to
what you are doing and use common sense.
Never install the light if you are having difficulty
concentrating or do not feel well.

Preparation

Required tools and material

The tools and materials specified are not included.
This information and these values are non-binding
14 GB/IE
and are only provided as a reference. The nature
of the material is determined by the individual local
conditions.
– Pencil / marking tool
– Voltage tester
– Cross-tip screwdriver
– Electric drill
– Edge cutter
– Drill (ø 6 mm)
– Slotted head screwdriver

Prior to installation

Important: Ensure that a qualified electrician, or
a person trained to carry out electrical installations,
performs the electrical installation.
Be sure the installation height of the light does not
present a risk of injuries.
Familiarise yourself with all the instructions and
diagrams in this manual, as well as with the light
itself, before you install it.
Before installation ensure that the circuit, to which
the light will be connected, is not energised. To
do so, remove the fuse or switch off the circuit
breaker in the fuse box (Position 0).
Use the voltage tester to verify the de-ener-
gised status.
Installation
Note: The models 14144905L and
14144906L have a motion detector
range of approx. 8 m at an installation height
of approx. 2.5 m.
All models:
Remove all packaging material from the light
before installing.
Carefully remove the light housing cover
(see Fig. B).
Note: If using a tool (e.g. screwdriver) to loosen
the brackets, be careful not to break off or
damage any parts.
with a
10
7