Technical Specifications - Kärcher EWM 2 Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für EWM 2:

Originalbetriebsanleitung (248 Seiten)

Inhalt

Inhaltsverzeichnis

Verfügbare Sprachen

Formation of foam in the floor head and on

the floor

Note

Slight foam formation in the floor head during operation

is normal and does not impair functionality. Further

measures are only necessary when there is excessive

foam formation (e.g. streaks of foam on the floor).

Incorrect detergent or incorrect dosage.

 Use only KÄRCHER detergent and be sure to use

the correct dosage.

Device operation is based on the cleaning rollers re-

moving dirt. Dirt and detergent residues from floor cov-

erings collect in the waste water tank. This can lead to

foam formation under some circumstances.

 Clean the waste water tank, floor head cover and

cleaning rollers.

Poor cleaning result

The rollers are dirty.

 Clean the rollers.

Rollers are not being sufficiently moistened.

 Moisten the rollers by moving back and forth over

the same position.

Incorrect detergent or incorrect dosage.

 Use only KÄRCHER detergent and be sure to use

the correct dosage.

Foreign detergents are present on the floor.

 Remove all detergent residues from the rollers us-

ing water.

 Clean the floor several times using the device and

clean rollers, without using detergent. This re-

moves detergent residues from the floor

Rollers do not turn

Rollers are blocked.

 Remove rollers and check if an object has become

stuck in the rollers.

 Check that the rollers are screwed in as far as they

will go onto the roller holder.

 Check that the floor head cover is correctly seated.

For this, remove the cover and then fit it back in

place.

Water vacuuming not optimum

Floor head cover not installed correctly

 Check that the floor head cover is correctly seated.

For this, remove the cover and then fit it back in

place.

The rollers are worn out.

 Replace the rollers.

Appliance is leaking waste water.

Waste water tank is overfilled.

 Empty the waste water tank right away.

Waste water tank does not fit properly in the appliance.

 Check that the floor head cover is firmly seated on

the waste water tank.

 Check that the waste water tank flaps are correctly

closed.

Removing the handle from the basic unit

ATTENTION

Do not remove the handle from the basic unit once it has

been assembled.

The handle may only be removed from the basic unit if

the unit is sent out for service purposes.

Illustration

See illustration at the end of the operating instructions

 Insert screwdriver at a 90 degree angle in the small

opening at the rear side of the handle and remove

handle.

ATTENTION

Please ensure that the connection cable between the

basic unit and the handle are not damaged.

Pull carefully to avoid damaging the device.